Note the assembly codes 'Sl', 'Br', 'S4' to the right of the number image by () On lenses The serial numbers of lenses can commonly be found on the front bezel, but also be on the side or on the rear cell. Schneider Kreuznach Xenar 240mm f 4.5 fitted in this The serial nº (292516) is found on the front bezel image by () Schneider Kreuznach Radionar f/3.5 F=5cm fitted in this The serial nº (489047) is found on the rear cell image by () Nikkor HC 28mm f/3.5 The serial nº (851688) is found on side of the lens barrel image by () On shutters Camera makers frequently made sure that the serial number of the shutter was out of sight by judiciously orienting the shutter casing. Serial number lookup model. The use of a speculum (dentist's mirror) allows to read the number even if it is facing the camera's folding bed. The introduction of the GeniSys™ control system has been well received by the field. To unlock the power of the GeniSys™ control, the GeniSys™ Contractor Tool has been made available to the technician. ![]() It can retrieve the data to help solve problems and reduce time on the job. There are a few important facts to consider when using the Contractor Tool. Software Hack2018-7-25 Bosch Automotive Service Solutions 28635 Mound Road, Warren, MI 48092 USA. Customer Service: 1-800-533-6127 Tech Service: 1-800-533-6127 Email: [email protected]. The tool is specifically designed for use on the Beckett GeniSys™ control. Do not attempt to use it on other brands of controls. The Tool communicates the current status and last fifteen cycles of history for ease of diagnosis. It also allows the contractor to program pre-time and post-time delay intervals, making the GeniSys™ a universal control. User Tips • The Contractor Tool is designed to access the data through the COM port 1 or COM port 2 of the GeniSys™ control, which are 4 pin connectors. (See Figure 2) • Note: The installation of the cord is position-sensitive and must be inserted with the “UP” on top when using COM port 1. (See Figure 3) If the optional COM port 2 is used, the “UP” is to be positioned to the inside of the control. (See Figure 4) • The GeniSys 12VDC control COM port can be accessed at the bottom of the control. The “UP” is to be positioned towards the terminals. (See Figure 6) NOTICE: This tool is NOT designed for use on any Non-GeniSys Control or Equipment. (See Figure 4) Non-intended use can cause damage to the Contractor Tool or the control being tested, may potentially alter control or system operation, and will not be covered under Beckett’s warranty.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2019
Categories |